Panasonic CF-30 Series

51
Disabling/Enabling Wireless Communication
You can automatically disable the wireless LAN connection and the wireless WAN connection when a LAN cable is connected
to your computer. You need to install the Wireless Connection Disable Utility to use this function.
Installing the utility
1 Log on to Windows as an administrator.
2 Click [start] - [Run] and input [c:\util\wdisable\setup.exe], and click [OK].
3 Follow the on-screen instructions to install the Wireless Connection Disable Utility.
Checking the status of the wireless connection
NOTE
z The Wireless Switch Utility should also be installed so that the Wireless Connection Disable Utility works. The Wire-
less Switch Utility has already been installed at the factory.
z To use the utility, select [Enable] in [Wireless Switch] in the [Advanced] menu of the Setup Utility.
z The utility does not automatically disable the Bluetooth connection.
 Status indication
After installation, the Wireless Connection Disable Utility is automatically started after a user is logged in. An icon appears on
the notification area.
: Indicates that
• the utility is enabled, and
• the wireless connection is disabled since a LAN cable is connected.
: Indicates that
• the utility is enabled, and
• the wireless connection is enabled since no LAN cable is connected.
: Indicates one of the following statuses;
• The utility does not monitor the LAN port status,
• the Wireless Switch Utility has not been started, or
• the built-in LAN device is not detected or disabled with the device manager.
Wireless Connection Disable Utility