5
Touchscreen
<Only for model with touchscreen>
You can use the touchscreen function to perform the same operation as the touch pad and mouse. Touch the screen surface
with the stylus (included).
z To right-click
A Click on the notification area.
changes to .
B Click the object you want to right-click.
returns to .
NOTE
z You need to make the following setting for each user.
A Click [start] - [All Programs] - [Fujitsu Touch Panel (USB)] - [Touch Panel Configuration].
B Select the settings, and then click [OK].
z Do not add a check mark to [Delete Cursor] since the display may be distorted.
z If you add a check mark for [Use] in [Hold [Ctrl] key down + Touch the screen] of [Touch Panel Configuration], touching
the screen may always be recognized as a right-click. To return to the normal operation, press
Ctrl
on the keyboard.
z The touchscreen function does not work in the Setup Utility, in the full screen of [Command Prompt] or in Recover Pro
(Î page 73).
1 Run [Touch Screen Calibration Utility].
Click [start] - [All programs] - [Fujitsu Touch Panel (USB)] - [Touch Screen Calibration Utility].
2 Using the stylus, touch each of the 12 “+” target marks one by one until it blinks, and then
press
Enter
.
3 Press
Enter
.
NOTE
z Perform the touchscreen calibration for each user.
Touchscreen Calibration
To Next Page
Loading...
