24
PC Card / ExpressCard
You can insert the following cards.
z ExpressCard/34 or ExpressCard/54 to the ExpressCard slot (A)
z PC Card Type I (3.3 mm) or II (5.0 mm) to the PC Card slot (B)
NOTE
z The following types of card are not supported:
PC Card Type III (10.5 mm), ZV card, SRAM card, FLASH ROM card (excluding ATA interface type), and other cards
that require 12 V of operating voltage.
z Dummy cards are inserted into both of the slots at the factory.
First remove the dummy cards. (Î page 25 Step
2)
z Be sure to insert each dummy card when the slots are not in use.
z Insert the appropriate dummy card in the correct card slot. Insert the dummy PC Card in the PC Card slot, and the
dummy ExpressCard in the ExpressCard slot.
Inserting a dummy card in the wrong slot may cause malfunction of the computer.
Preparation
Attach the device for the media containing the card driver (e.g., CD-ROM). Equipment connected to the multimedia
pocket cannot be recognized if connected after the card driver installation screen appears.
To insert the card
1 Slide the latch (C) and open the cover.
2 Insert the ExpressCard (left slot) (D) or the PC Card (right slot)
(E) with the label side up until it securely fits in to the slot.
z For further information, refer to the instruction manual of the card.
Inserting/Removing the Card
To Next Page
Loading...
