15
Standby/Hibernation Functions
When [Standby]*
1
or [Hibernate] is selected as the setting for [When I close the lid of my
portable computer] in the following*
2
, the computer will enter either the standby or hiber-
nation mode when the LCD panel is closed. Operation will resume when the LCD panel
is opened. Even if the display is closed after the computer has entered either the standby
or hibernation mode, operation will resume when the display is opened. If the computer
does not resume when the LCD panel is opened, slide the power switch.
*
1
Windows XP : [Stand by]
*
2
Windows 2000 : [Control Panel] - [Power Options] - [Advanced]
Windows XP : [Control Panel] - [Performance and Maintenance] - [Power Options]
- [Advanced]
Resuming Operation
When resuming operation, avoid the following:
• Touching the keyboard (except for password input), pointing device (touch pad,
external mouse, etc.), or power switch.
• Connecting or disconnecting the AC adaptor.
• Closing or opening the display.
After the display returns, the computer needs about 15 seconds to reinitialize.
Do not shut down or restart Windows, or enter either the standby or hibernation
mode again during this time, as this may subsequently cause Windows to oper-
ate abnormally.
CAUTION
Slide the power switch
Windows 2000
When the computer enters standby/hibernation mode and then resumes while a
USB 1.1 device (e.g., USB floppy disk drive (optional)) is connected to the USB
port on the left side, a device disconnection warning message may appear on the
screen, but this will not impede the computer’s operation.
NOTE
To Next Page
Loading...
Need help?
General