47
Setup Utility
Running the Setup Utility
1 Slide the power switch, and immediately hold down F2
2 Release the key when the Setup Utility starts up
If [Enter Password] is displayed, enter your password.
When a User Password is entered, some contents cannot be changed ( page 16).
If you fail to press F2 at the right moment, the Setup Utility will not start up.
In this case, power off the computer and try again.
To close the Setup Utility, press Esc , select the exiting method in [Exit]
menu, then press Enter .
NOTE
F1 :To display the corresponding “help” file.
Esc :To display [Exit] menu.
:To move among the items.
:To move among the menus.
F5 F6 :To move among the values.
Enter :To display sub-menu of each item selected by .
F9 :To set default settings (except the password).
(When starting up the Setup Utility with the User Password, this key
is not available.)
F10 :To save the settings and exit.
Key Operations
When setting date and time, Tab can be used to move the cursor.
NOTE