Panasonic CF-R1 Series

50
Setup Utility
Disable
Enable
Disable
Enable
Leave Set
Set and Eject
To the sub-menu
To the sub-menu
Disable
Enable
Disable
Enable
No Protection
Protected
To the sub-menu
Password on boot
SD Startup*
1
SD Setting Method*
1
*
2
Clear registered SD card*
1
Set Supervisor Password
Display Boot Menu
Hard Disk Lock*
3
User Password Protection
Set User Password*
3
Security Menu
Password on boot: [Enable]
Set Supervisor Password: [Enter]
Display Boot Menu: [Enable]
Hard Disk Lock: [Disable]
User Password Protection: [No Protection]
Set User Password: [Enter]
*
1
This is displayed only when an SD memory card has been registered.
However, [SD Startup] and [SD Setting Method] cannot be set if [Pass-
word on boot] is set to [Disable].
*
2
This can be set only if [SD Startup] has been set to [Enable].
*
3
Setting impossible when the Supervisor Password is not set.
( : Default)
Parameters
When the Setup Utility is started up with the User Password:
[Clear registered SD card], [Set Supervisor Password] and [Hard disk Lock] will not
be displayed.
The User Password can be changed only when [User Password Protection] has
been set to [No Protection]. The User Password cannot be deleted.
NOTE