62
For CS-A18MKD, CS-A24MKD and CS-A28MKD
12.8 Horizontal Airflow Direction Control
12.8.1 Auto Control
• When the horizontal airflow direction is set to Auto using the remote control, the vanes swings left and right as
shown in the diagram.
• When stopped with remote control, the discharge vane is reset, and stop at the reset position.
• During Cooling operation or Soft Dry operation, indoor fan motor may stop to rotate at certain periods. At that
condition, the vane will stop swinging and rest at face front position.
• During Heating operation, the piping air temperature reaches 38°C, the vanes swings left and right. When the
piping air temperature falls to 35°C, the vanes will stop swing and rest at face front position.
For CS-A9MK and CS-A12MK For CS-A18MK, CS-A24MK and CS-A28MK
12.8.2 Manual Control
• When the horizontal airflow direction is set to Manual using the remote control, the automatic airflow is released
and the airflow direction vane move left and right in the range shown in the diagram.
• The louver can be adjusted by pressing the button to the desired vane position.
• When stopped with remote control, the vanes is reset and stopped at reset position.
For CS- A9MK and CS-A12MK
Pattern 1 2 3 4 5
Airflow Direction Patterns of Remote Control
Vane Angle (°) 30° 60° 45° 15° 0°
For CS-A18MK, CS-A24MK and CS-A28MK
Pattern 1 2 3 4 5
Airflow Direction Patterns of Remote Control
Vane Angle (°) 26° 52° 39° 13° 0°
Closing
position
/ 148°
Lower limit for heating mode
Horizontal
17°
27°
42°
33°
52°
Upper limit for
heating mode
To Next Page
Loading...
