•
• •
•
Serviceability
−
− −
−
Self diagnosis
−
− −
−
Test Run at both Cooling and Heating rated frequency
•
• •
•
Built-in drain pump (Cassette and Duct type)
−
− −
−
A drain pump is built in.
The pipe can rise to 200m above the drain outlet.
2 About Lead Solder (PbF)
2.1. DISTINCTION OF PbF P.C. BOARD
P.C. Boards (manufactured) using lead free solder will have a PbF stamp on the P.C. Board.
2.2. CAUTION
•
• •
•
Pb free solder has a higher melting point than standard solder; Typically the melting point is 50 - 70 °F (30 - 40 °C) higher.
Please use a high temperature solder iron and set it to 700 ± 20 °F (370 ± 10 °C).
•
• •
•
Pb free solder will tend to slash when heated too high (about 1100 °F/ 600°C).
If you must use Pb solder, please completely all of the Pb free solder on the pins or solder area before applying Pb solder. If
this is not practical, be sure to heat the Pb free solder until it melts, before applying Pb solder.
4
CS-ME7DKEG CS-ME10DD3 EG / CS-ME10DTEG CS-E15DB4EW
To Next Page
Loading...
Need help?
General
