86
13.8 Timer Control
• There are 2 sets of ON and OFF timer available to turn the unit ON or OFF at different preset time.
• If more than one timer had been set, the upcoming timer will be displayed and will activate in sequence.
13.8.1 ON Timer Control
• ON timer 1 and ON timer 2 can be set using remote control, the unit with timer set will start operate earlier than
the setting time.
This is to provide a comfortable environment when reaching the set ON time.
• 60 minutes before the set time, indoor (at fan speed of Lo-) and outdoor fan motor start operate for 30 seconds to
determine the indoor intake air temperature and outdoor air temperature in order to judge the operation starting
time.
• From the above judgment, the decided operation will start operate earlier than the set time as shown below.
13.8.2 OFF Timer Control
OFF timer 1 and OFF timer 2 can be set using remote control, the unit with timer set will stop operate at set time.
13.9 Auto Restart Control
• When the power supply is cut off during the operation of air conditioner, the compressor will re-operate within
three to four minutes (there are 10 patterns between 2 minutes 58 seconds and 3 minutes 52 seconds to be
selected randomly) after power supply resumes.
• This type of control is not applicable during ON/OFF Timer setting.
• This control can be omitted by open the circuit of JP1 at indoor unit printed circuit board.
13.10 Indication Panel
LED POWER TIMER POWERFUL/QUIET nanoe-G ECONAVI AUTO COMFORT
Color Green Orange Orange Blue Green Green
Light ON Operation ON Timer Setting ON
POWERFUL/QUIET
Mode ON
nanoe-G
ON
ECONAVI ON
AUTO COMFORT
ON
Light OFF Operation OFF Timer Setting OFF
POWERFUL/QUIET
Mode OFF
nanoe-G
OFF
ECONAVI OFF
AUTO COMFORT
OFF
Note:
• If POWER LED is blinking, the possible operation of the unit are Hot Start, during Deice operation, operation
mode judgment, or ON timer sampling.
• If Timer LED is blinking, there is an abnormality operation occurs.
To Next Page
Loading...
