Panasonic CS-S18JKQ - Page 71

71
15.1.3 To remove power electronic controller
Figure 3
Figure 4 Figure 5
Figure 6
Hook (left hand side)
7. Remove the control board cover
by releasing the hook.
8. Detach receiver complete.
10. Detach the CN-DISP
connector then remove
the indicator complete.
11. Detach the HV+ (White) &
HV- (Black) terminal
wires, CN1 and GND then
remove the high voltage
generator.
14. Detach 5 connectors as labeled from
the electronic controller. Then pull out
main controller gently
CN-Data
CN-TH
CN-CLN
CN-STM1
13. Pull out the main
electronic controller and
power electronic
controller halfway.
12. Remove screw to
remove terminal board
complete.
9. Detach the Earth wire
CN-STM2
15. Detach the AC303, RY-PWR and
CN-PCFM connectors from the
electronic controller. Then pull out
power electronic controller gently.
RY-PWR connector
(Black and brown)
CN-PCFM
AC303 (White)