73
Figure 10
Figure 11
Figure 12
22. Remove the bearing by pulling it
out gently
21. Remove the screw from the
evaporator.
23. Push the holdfast to the left and lift up the evaporator.
25. Fan motor can be removed after the
removal of cross flow fan.
Reminder: To reinstall the fan motor, adjust
the fan motor connector to 45° towards you
before fixing control board.
24. Remove the cross flow fan from
the unit by pulling it to the left and
downward.
Evaporator
Reminder: To reinstall the cross flow
fan, ensure cross flow fan is in line as
shown in figure 12
Cross Flow Fan
To Next Page
Loading...
