Panasonic CS-Z20VKEW

23
English
Connection network using WPS mode (method 1)
1
Press the “WPS” button from the
router that will be connected to an air
conditioner.
• Check the status of Wireless LAN LED
on the remote control. If the Wireless
LAN LED is OFF, press the Wireless
LAN
button to enable the Wireless
LAN connection.
WƌĞƐƐƚŚĞtW^ďƵƩŽŶŽŶƚŚĞƌŽƵƚĞƌƚŽĞƐƚĂďůŝƐŚ
ĐŽŶŶĞĐƟŽŶ
dĂƉEĞdžƚĂŌĞƌƚŚĞƌŽƵƚĞƌŝƐƌĞĂĚLJĨŽƌĐŽŶŶĞĐƟŽŶ
Connection Guide
Step 1
Step 2
Step 3
Next
Cancel
2
Ensure Wireless LAN LED is ON. Press
and hold the Wireless LAN
button
for 5 seconds until “1” is shown on the
remote control and press
SET
pointing
to the air conditioner.
If Wireless LAN LED is OFF during the connecƟon
setup, please press “Wireless LAN” buƩon once
to enable the Wireless LAN before proceeding to
step 1 .
1. Press and hold “Wireless LAN” buƩon for 5 secs
unƟl easy seƫng “ 1 ” is shown .
2. Point remote control to air-condiƟoner and
press “SET” buƩon once.
3. AŌer step 1 & 2 have been done, tap “Next”.
Connection Guide
Step 1
Step 2
Step 3
Cancel
Next
SET
CANCEL
4
If the Wireless LAN LED keep blinking,
check the wireless router connection.
Searching for air-condiƟoner.
Please wait…
Connection Guide
Step 1
Step 2
Step 3
Cancel
3
When the connection of air conditioner
to router is successful, the Wireless LAN
LED changed from blinking to ON.
Connection Guide
Step 1
Step 2
Step 3
When the connecƟon of air-condiƟoner to router
is successful, the Wireless LAN LED changes from
blinking to ON.
*It may take up to few minutes before changes
to ON.
Next
If the Wireless LAN LED is ON, tap “Next”.
If Wireless LAN LED keep blinking, tap “Check”
Cancel
Check
ΎtŝƌĞůĞƐƐ>E>ƐƉŽƐŝƟŽŶĂŶĚĐŽůŽƵƌǀĂƌŝĞƐ
ĨŽƌĚŝīĞƌĞŶƚŵŽĚĞůƐ
How to use