Panasonic CZ-RWS3

ENGLISH
13
(EN)
2. Insert two LR03 size batteries.
• Put the batteries in with the polarity [+/–] as
showninthegure.
3. Gently insert one end of an unfolded
paper clip (or a similar object that can
t) into the RC reset hole and press the
RC reset button inside the hole.
• Take the batteries out and insert again if the
timedisplayisnot“ ”or“ ”.
RC reset button
4. Put the battery cover back on.
■ Notes on batteries
• The battery life is approximately 1 year.
• Reception may become poor or display on the remote controller fades when
batteries are low.
• If the remote controller will not be used for a long period of time, remove the
batteries. (In order to avoid a battery leak.)
• Emergency operations can be performed on the unit when the batteries run out.
(See page 12)
■ Replacing batteries
• Replace both batteries at the same time with 2 LR03 size batteries.
• Do not use rechargeable batteries (NiCd, NiMH, etc.) because their size, shape, and
some performance are different.
• Dispose of the old batteries at the designated sites in your community.
• The unit is restored with the factory setting when batteries are removed.
• After changing the batteries, reset the current time. (See page 14)