Panasonic CZ-RWS3

12
(EN)
Names and Operations (Cont.)
Emergency operation
Use [Emergency Operation] in the following situations when there is an
urgent need.
• When the remote controller’s batteries have failed.
• When the remote controller is broken.
• When the remote controller is lost.
1. Press [Emergency Operation] of the receiver.
• The OPERATION lamp is lit.
• Auto operation starts. If Auto operation is not possible, the unit starts
cooling if the room temperature at the time is 24 °C or higher; otherwise,
the unit starts heating.
• The operation stops if you press [Emergency Operation] again.
Note
• If non-cooling/heating free type is being used, it will beep twice and the operating
lamp will light up on the display; if the timer and standby lamps blink alternately, a
conictbetweentheheatingandcoolingexists,sotheunitcannotoperateinthe
desired mode. (On models that do not have an Auto function, even if Auto is
selected, it works in the same way.)
• When the local operation is disabled by a central control device or similar cause,
and if the Start/Stop
, Fan speed , Flap , Temperature setting
/ , Mode select or Energy saving button is pressed, the unit
will beep 5 times and the change will not be made.
Installing Batteries
1. Remove the battery cover.
• Pinch the handle and open while pressing it
towards the ▼ mark.
Battery cover
Handle