Panasonic CZ-RWS3

20
(EN)
Lock Individual Flap
(Supported models: 4-way ceiling cassette type)
Youcansettheapforeachairoutletindividuallyaccordingtotheroom
condition.
• Eveniftheapsettingischangedwith
(P.19),theapdirections
set here are not changed.
1. Press and at the
same time for 4 seconds or
longer.
• “  ”startsblinkingandthe
setting screen is displayed.
2. Press / to select the
indoor unit to set, then press
.
• Every time you press /
toswitchbetween“U1↔U2↔
…
↔U8↔AL(Allindoorunitsthat
are connected to the remote
controller)”,thebuzzersounds
from the corresponding receiver.
• When settable: 1 short beep
• When not settable*: 1 short
beep followed by 1 long beep
* When the indoor unit is not
connected or does not support
this function.
3. Press / to select the air outlet.
• Every time you press / ,itcyclesfrom“F1↔F2↔F3↔F4
↔AL(Alltheairoutlets)”.
• The square mark (indented ) on the panel
of the indoor unit indicates air outlet No. 1.
There are some models that do not have a
square mark (indented ).
• The air outlet No. changes according to the
installation direction. Check by actual
operation.
1
1, 2, 4
5
2, 4
3
Indoor unit
Air outlet
Flap
F1
F2
F3
F4
Square mark (indented )