Panasonic CZ-RWS3

ENGLISH
19
(EN)
4. Press / to set the temperature.
MAX (°C) MIN (°C)
Auto
27 17
Heat
30 16
Dry
/ Cool
30 18
• Temperature settings cannot be made in Fan mode.
• The temperature range that can be set varies depending on the model.
• The maximum temperature varies depending on the system and
operating condition. See page 28 for how to change the maximum
temperature.
5. Press
to select the ap direction.
• Every time you press ,itcyclesfrom“ →  →  →  →  → 
(Swing)→ (Stop)”.
• If you press againwhiletheapisswinging,youcanstoptheap
from swinging and set it in place as desired.
• Whentheunitisinheatingstandby,theap(up-downwinddirection
plate) faces upwards.
• The available functions differ depending on the indoor unit being used.
• “ ”isdisplayedifthefunctionisnotavailable.
• Never try to manually move the ap (up-down wind direction plate)
that is operated by the remote controller.
Stop: Press .
• If you cannot turn the air conditioner off in the normal way, disconnect
the power to the indoor unit and contact the dealer where the product
was purchased.
• When the unit is stopped with the remote controller, the fan on the
outdoor unit may continue to run for a while.
< Auto operation >
It heats or cools automatically via the differences between the set temperature
and the room temperature.
Auto operation is available only when identical refrigerant system inside all the
indoor units or cooling/heating free-type are under control as 1 group. When
using gas heat pump (GHP) air conditioners, contact the dealer where the
product was purchased.