Panasonic CZ-RWS3

ENGLISH
17
(EN)
2. Press
RC
ADR
to select the address of the receiver you want to
control, and press
.
• Every time you press
RC
ADR
,itcyclesfrom“ALL(Alltheaddresses)→
1 → 2 → 3 → 4 → 5 →6”.
• If it corresponds to the receiver’s address setting, the buzzer sounds.
Note
• Set the address of the receiver as instructed in the operating instructions of your
receiver. Do not set by yourself. Contact the dealer where the product was
purchased.
■ For wall mounted type indoor unit
< Setting the address of the indoor unit >
1. Press [Emergency Operation] of the indoor unit for
4 seconds or longer.
• OPERATION lamp, TIMER lamp, and then STANDBY lamp repeatedly
light one after the other for 1 second each to indicate the unit is ready for
address setting.
< Setting Remote Controller Addresses >
2. Set the address for the remote controller following the
procedure under the section “■ If not wall mounted type indoor
unit” (see page 16).
• RepeatStep2under“■Ifnotwallmountedtypeindoorunit”ifyouare
setting more units.
• The address setting ready status of the indoor unit ends if data
transmission is not received from the remote controller for 3 minutes.
• Press [Emergency Operation] on the receiver to end the address
setting ready status of the indoor unit.