ENGLISH
9
(EN)
1 remote controller can control a group of up to 8 indoor units.
(See page 28)
1. Operation Display
Displays the operation status.
(Thegureshowsallthe
statuses.)
2. Start/Stop button
Pressing this button once starts
and pressing again stops the
operation.
3. Fan speed button
Press to change the fan speed.
4. Flap button
Presstochangetheapdirection.
5. ECONAVI button
ECONAVI
Press to set ECONAVI.
6. nanoe™ X button
nanoeX
Press to set nanoe™ X.
7. Ventilation button
Use this when connected to an
aftermarket fan.
8. Clock button
Use this to set the clock.
9. Cover
Press at the top center and then
slide down.
10. Transmitter
11. Temperature setting buttons
raises the temperature
setting 1 °C at a time.
lowers the temperature
setting 1 °C at a time.
12. Mode select button
Press to switch the operation
mode.
13. Energy saving button
Press to enable or disable energy
saving.
14. Filter button
Presstoturnoffthelterlampon
the receiver.
15. Timer setting buttons
/ / / / /
Use for operating with a timer.
16. RC reset button
RC
RESET
Use this button after changing the
batteries.
17. RC address button
ADR
Press to set addresses.
From this page, the names of
remote controller’s buttons will be
indicated with the above
illustrations.
E.g.: Start/Stop button
To Next Page
Loading...
