STEP 1 Connection
• You need to subscribe to a cable TV or satellite TV service to enjoy viewing their programming.
eConsult your service provider regarding appropriate cable TV box or satellite receiver.
eThis unit is not compatible with TV Guide On Screen systems broadcast by satellite.
@ to @ are indexes for Spanish Quick Reference.
Television
_) This unit
I Audio/video cable ÷ 75 £2coaxial
cable
(_ IR Blaste_
Insert the IR Blaster jack into
the G-LINK terminal.
The cable TV box is
controlled by an IR signal
transmitted through the IR
Blaster.
When selecting channels on
this unit, the corresponding
channels on the cable TV
box also change accordingly.
eMake sure to use the IR
Blaster (included). Only
use the included IR
Blaster.
_) Use L3 (not Lt).
@ Audio/video cable
@ Setting the IR Blaster
J beIow
d
÷ For more information on connections (J page 7)
• Should ! use the AUD!O/V!DEO OUT terminal or
the RF OUT terminal?
If your cable TV box!satellite receiver has both AUDIONIDEO OUT
terminals and RF OUT terminals, we recommend connecting the
AUDIO/VIDEO OUT terminal with the unit's L3 terminal Using this
connection provides better picture quality.
eThe S-VIDEOterminal achieves a more vivid picture than the
VIDEO terminal.
_) Cable TV box/
satellite receiver
@75 _ coaxial,
From antenna or
cable TV jack
I Setting the IR Blaster
Place the IR Blaster in front of tile signal sensor of the cable TV
box.
@ Read the cable TV box operating instructions regarding
positioning of the signal sensor.
_) If necessary, use the double sided adhesive tape (included) to
secure the IR Blaster to a flat surface.
e.g. Television stand surface
_) Cable TV box
@ If you peel off the adhesive tape, the
surface may become damaged.
Once you have confirmed the cable TV
box is operating correctly, secure it by
attaching the adhesive tape.
To Next Page
Loading...
