20
RQT9167
Recording Television Programmes
¦
DVD
DRIVE
SELECT
to select the HDD or DVD drive.
If you selected the DVD drive
OPEN
/
CLOSE
to open the tray (Button located on front of the unit).
– Insert a disc with enough remaining blank space and press
[ OPEN/CLOSE] again to close the tray.
– When the format confi rmation screen is displayed (¼ 25).
to select desired channel.
RECREC
– To select with the numbered buttons (¼ 18).
– When no channel setting is performed on the unit and broadcast
is recorded directly from the satellite receiver, select a channel
on the connected equipment and press [INPUT SELECT] to
select “AV2”.
REC MODE
to select the recording mode.
Recording mode (¼ 24)
Remaining time
RECREC
REC
REC
Preparation:
Turn on the television and select the appropriate video input to suit the
connections to this unit.
[RAM] If the disc is protected, release protection (¼ 58).
Pausing Recording
Press [ PAUSE].
– Press again to restart recording.
(The title is not divided.)
Stopping Recording
Press [ STOP].
Refer to “Important Notes for Recording” (¼ 23) and “Advanced Recording”
(¼ 24–26) for detail information on recording.
[HDD] [RAM] [-R] [-RW‹V›] [+R] [+RW]
Tips
[-RW‹V›] [+R] [+RW]
To use a new disc, formatting is
necessary.
Notes
[-R] [-RW‹V›] [+R] [+RW]
It takes about 30 seconds for the unit
to complete recording management
information after recording fi nishes.
You cannot change the channel or
recording mode during recording.
This unit cannot record NTSC signals
to discs that already have PAL signal
recordings. (However, both types of
programmes can be recorded onto the
HDD.)
Elapsed recording time
DMR-EX768EB.indb20DMR-EX768EB.indb20 2008/03/0610:02:322008/03/0610:02:32