68
RQT9167
After completing the above connections, proceed to the TV Tuning (¼ 13).
Adding a VCR: Connecting to a Television and a Video Cassette Recorder
To record from a VCR
Refer to “Recording from an External Device” (¼ 34).
Using a fully wired 21-pin Scart cable
– You can use a variety of Q Link functions by connecting the unit to a Q Link compatible television (¼ 40).
– You can enjoy high-quality viewing by connecting the unit to an RGB compatible television.
“AV1 Output” in the Setup menu is set to “RGB 1 (without component)” or “RGB 2 (without component)” (¼ 65).
Make “AV2 Input” settings in the Setup menu (¼ 65).
Use of the RF coaxial cable
Keep the RF coaxial cables as far away as possible from other cables.
Do not roll up the RF coaxial cables.
Rear of TV
Rear of VCR
To the aerial
To household
mains socket
Rear of this unit
To household
mains socket
To household
mains socket
Before connection, turn off the mains for all connected equipment and read the appropriate operating instructions.
Be sure to read the Caution for AC Mains Lead on page 3.
Additional Connections
RF coaxial cable
The RF coaxial cable cannot
be used for showing pictures
from the unit. The unit must
be connected using another
method, e.g. 21-pin Scart cable
to show pictures from the unit
on the television set.
To Next Page
Loading...
Need help?
General
