Copying video
VQT4L31
45
Copying titles
To register the external HDD (USB HDD)
Refer to “Registering the USB HDD”. (> 62)
• You cannot copy the following titles to the USB HDD.
- Protected titles
- HD Video (AVCHD)
- SD Video (MPEG2)
1 Select “No”, then press [OK] in step 5 (> left).
2 Select the title, then press the yellow button.
Repeat this step to select titles.
3 Go to step 4 (> left).
About screen icons on the DIRECT
NAVIGATOR
Refer to “Screen icons”. (> 33)
1 Select the item in step 6 (> above).
2 Press [2, 1] to change the settings.
• Automatic Standby after Copy
On:
This unit is turned to standby mode when it is
not operated for approximately 5 minutes
after completing copy.
§1, 2
§1
“For recorded titles” only
§2
The title in the source media will be deleted.
1 Connect the USB HDD.
2 Press [DRIVE SELECT] to select “HDD”,
then press [DIRECT NAVIGATOR].
• If the DIRECT NAVIGATOR screen of
photo or music is displayed, press the red
button, then select “VIDEO”.
3 Select the title, then press the yellow
button.
A check mark is displayed. Repeat this
step.
• Press the yellow button again to cancel.
4 Press the blue button.
5 Select “Yes”, then press [OK].
• If you select “No”, you can change the
selection. (> right)
Start Time
Prog.Type:
Rec time
Channel Date Title Name
Movies
9:00 AM
6 Set other settings, then press [OK].
e.g.,
(> below, Setting the copying options)
7 Select “Yes”, then press [OK].
To change the selection
Setting the copying options
Standby status can be changed if required.
Please press OK to start copying.
OK
RETURN
Automatic Standby after Copy
Off
DMRPWT635GL_eng.book 45 ページ ２０１３年２月４日 月曜日 午後１時２５分
To Next Page
Loading...
