Troubleshooting
VQT4L31
92
Troubleshooting guide
(When a disc is inserted) There was something
unusual detected with the disc or the unit. The
unit is trying to restore to the normal operation.
Once the message disappears you can use the
unit again.
If it remains displayed, consult the dealer.
The unit fails to operate properly. Press [Í/I] on
the main unit to switch the unit to standby mode.
Now press [Í/I] on the main unit again to turn the
unit on.
The HOLD function is activated. (> 83)
There is something unusual. (The service number
displayed after H and F depends on the unit’s
condition.)
Reset the unit as follows:
1 Disconnect the plug from the household mains
socket, wait a few seconds, then reconnect it.
2 Press [Í/I] to turn the power on. (The unit may
be fixed.)
Request service from the dealer. Inform the
dealer of the service number when requesting
service.
If there is any problem, the following message is
displayed on the screen.
U88
U99
XHOLD
H or F
(“∑” stands for a number.)
When you experience problems with
Easy Network Setting
Wireless Settings
Display Check the following
A conflict with
other devices
occurred.
• Please wait a few moments,
and then try again.
A time out error
occurred.
• Setting of the Wireless router
for MAC Address etc.
• The signal may be weak.
• The SSID and the encryption
key of the Wireless router.
• Please wait a few moments,
and then try again.
An
authentication
error or a time
out error
occurred.
A device error
occurred.
• If the problem is not solved,
consult your dealer.
DMRPWT635GL_eng.book 92 ページ ２０１３年２月４日 月曜日 午後１時２５分
To Next Page
Loading...
Need help?
General
