Troubleshooting
VQT4L31
85
The remote control does not work.
• The remote control and main unit are using
different codes. Change the code on the remote
control.
• Software (firmware) is updating when “UPD
/” is displaying on the unit’s display. Wait until
the update is completed. (> 82)
• The HOLD function is activated. (> 83)
Startup is slow.
• Startup takes time in the following situations:
- A disc is inserted.
- The clock is not set.
- Immediately after a power failure or the AC
mains lead is connected.
- When a BD-J application is executing.
- When the “Quick Start” is not activated. (> 78)
• Startup of this unit may be slower depending on
the TV settings.
“0:00” is flashing on the unit’s display.
• Set the clock. (> 67, 79)
The clock does not display on the unit when
switched to standby.
• The clock does not display when “Quick Start” is
not activated. (> 78)
Screen size is wrong.
• Check the “TV Aspect” or “Aspect for 4:3 Video”.
(> 74)
• Adjust the aspect ratio setting on TV.
• If you connect to 4:3 TV, set “HDMI Video
Format” to “576p/480p”. (> 67, 75)
The black screen appears on the TV.
• This phenomenon may occur, depending on the
TV setting, when “Quick Start” is activated.
Depending on the TV, this phenomenon may be
prevented by reconnecting to a different HDMI
input terminal.
TV reception is not displayed.
• Broadcast signals are not output from this unit’s
RF OUT terminal. Select “On” in “RF OUT
( Aerial Signal )”. (> 67, 78)
Picture does not appear with the HD quality
although HD setting was made.
• The pictures are output with 576p/480p
depending on the title.
Unit's display
Press and hold [OK] and
the indicated number
button at the same time
for more than 5 seconds.
(> 79)
Displays
TV screen and video
DMRPWT635GL_eng.book 85 ページ ２０１３年２月４日 月曜日 午後１時２５分
To Next Page
Loading...
Need help?
General
