18
5If the [Jog switch] is pressed while in the status condition
when sensing object ‘B’ is present that has an incident light
intensity in between that of sensing object ‘A’ and sensing
object ‘C’, the display will blink and indicate the incident light
intensity reading.
And then the unit will enter the ‘P-3’ setting state.
The status condition when sensing object ‘B’ is present that
has an incident light intensity in between that of sensing
object ‘A’ and sensing object ‘C’.
Upper and lower limits have
not been correctly set.
The status condition when sensing object ‘C’ is present
that has the greatest incident light intensity.
Press the MODE key 5 times
or keep it pressed for 2 sec.
or more.
0The output 1 will again be displayed, indicating that
configuration is now complete.
APress the [MODE key] 5 times or keep it pressed for 2 sec.
or more, the amplifier will return to ‘RUN mode’ (normal
sensing operation).
6If the [Jog switch] is pressed while in the status condition
when sensing object ‘C’ is present that has the greatest
incident light intensity, the display will blink and indicate the
incident light intensity reading.
8The setting for ‘lower limit value 1_SL’ will be displayed.
9The setting for ‘upper limit value 2_SL’ will be displayed.
7The display will indicate whether the upper and lower limits
have been correctly set or not.
• If ‘ ’ is blinking… the upper and lower limits have
been set correctly.
• If ‘ ’ is blinking… the upper and lower limits have not
been set correctly.
Lower limit value 1_SL
Upper limit value 2_SL
Incident light
intensity of P-3.
Press the
Jog switch.
Incident light
intensity of P-2.
Press the
Jog switch.
To Next Page
Loading...
