4-4.
Threshold Value Fine Adjustment Mode [when using FX-301(P)(-HS) or FX-305(P) normal mode]
1 Press the [MODE key] twice to select ‘threshold value fine
adjustment mode’.
2 FX-305(P): Turn the [Jog switch] to select the desired ‘output’
for setting.
3 If the [Jog switch] is pressed, the ‘output’ will be set.
4 The current ‘threshold value’ will be displayed.
* The factory setting is;
FX-301(P): 40, FX-301(P)-HS: 80
FX-305(P) output 1: 80, FX-305(P) output 2: 120
5 If the [Jog switch] is turned toward the ‘’ or ‘’ direction,
the ‘threshold value’ will change and the new value will blink.
If an increased ‘threshold value’ is desired,
turn the [Jog switch] toward the ‘
’ direction.
If a decreased ‘threshold value’ is desired,
turn the [Jog switch] toward the ‘
’ direction.
* When using the FX-301(P) in LONG mode, it is
recommended that you set the threshold value to ‘15 digits’
or more.
7Press the [MODE key] 4 times or keep it pressed for 2 sec.
or more, the amplifier will return to ‘RUN mode’ (normal
sensing operation).
6If the [Jog switch] is pressed, the digital display will quickly
blink 3 times, confirming the setting of the currently
displayed ‘threshold value’.
In case of
turning toward
the ‘’.
Turn the Jog switch to set the
desired threshold value.
In case of
changing
threshold value
to 35.
Turn the
Jog switch.
Press the
Jog switch.
Press the MODE key
4 times or keep it pressed
for 2 sec. or more.
Turn the Jog switch to select the
desired output.
Press the
Jog switch.
Output 1 Output 2
Press the
MODE key twice.
The digital display will quickly
blink 3 times to confirm the value.
This mode allows fine adjustment of the ‘threshold value’ setting.
In case of FX-301(P)(-HS)
In case of FX-305(P)
The current
threshold
value
19
To Next Page
Loading...
