Wi-Fi/NFC
Operating the camera using a smartphone/tablet
SQW0206
- 217 -
Select [Via Network] or [Direct] and press [MENU/SET]
●
When connecting with [Via Network]
(On the camera)
Connect the camera to a wireless access point (→250)
(On your smartphone)
Set Wi-Fi function to “ON”
Select the wireless access point you connected to the camera, and set
Start “Image App” (→193)
●
When connecting with [Wi-Fi Direct] or [WPS Connection] in [Direct]
(On the camera)
Connect the camera to a smartphone (→253)
(On your smartphone)
Start “Image App” (→193)
●
When connecting with [Manual Connection] in [Direct] (→195)
Select the device you wish to connect to
• When the connection is established, the confirmation screen for the transmission
setting is displayed. Check the setting and press [MENU/SET]. To change the
send setting, press the [DISP.] button. (→258)
Select [SINGLE] or [MULTI]
• To change the setting or disconnect, press [Wi-Fi] button. (→190)
■
When [SINGLE] is selected
Select the picture
Select [Set]
■
When [MULTI] is selected
Select the picture (repeat)
• If selected again, the setting will be cancelled.
Select [OK]
• The number of pictures that can be sent by
[MULTI] is limited.
• Confirmation screen is displayed. If you select [Yes], the operation is executed.
To Next Page
Loading...
