24
Restoring the back up data to the unit
1. Turn the unit ON.
Perform the following: Function MENU - Setup- Basic Settings - Others - Initialize - Shipping Condition.
2. Start Tuner Service Mode.
3. There are many port models of USB, you need to make sure other USB ports don't connect USB memory and USB-HDD.
4. Insert the USB in save data to the unit.
5. Using Remote Controller, move the cursor to userís setting information backup display position (Refer to below) on Tuner Ser-
vice Mode display.
6. Press [ENTER].
After "Try → OK" is displayed, the data is restored to USB.
(Refer to below)
When OK(***) is displayed, the data is successfully exported.
7. Remove the USB from the unit.
8. Turn the unit OFF to finish Tuner Service Mode.
To Next Page
Loading...
