25
3.10. Description of the Self Diagnosis <Operation Method, Details>
3.10.1. How to check the diagnosis code
This device can display the device information with a 16 digit number (Diagnosis code) on the monitor in order to promptly check
the device status.
3.10.1.1. Procedure of the diagnosis code check
1. Turn power on. (E-E mode without recording or running as a server)
2. Press and hold [5], [9] and [Red] buttons on the remote control simultaneously for 5 seconds or more until front display
indicates "70 RET" as shown below.
3. Press [POWER] button on the main unit or [ ] on the remote control several times until front display indicates "96 DIC".
Front display indicates as follows by pressing [POWER] or [ ] button.
* If front display indicates "-- -- --" or enter to the other mode, reset by pressing [POWER] button and repeat from first step.
4. Press [OPEN/CLOSE] button on the main unit or [OK] button on the remote control to run self diagnosis.
To Next Page
Loading...
