67
2. Lift up the Upper Base Ass'y,and pull it out to the direction
of arrow.
9.12.2. Tray
1. Perform the step "9.12.1.Upper Base Ass'y".
2. Insert the Paper Clip into the hole of the bottom side,and
slide it to the direction of arrow until it can be.
3. Pull the Tray to the direction of arrow.
Notes when attaching the tray:
Pull the Slide Cam to the left side and insert the tray
when attaching.
9.12.3. Pulley Gear, Belt and Mid Gear
1. Perform the step"9.12.2.Tray".
2. Push the post to the direction of arrow by using the
slotted screwdriver.
3. Remove the Pulley Gear,Belt and Mid Gear.
To Next Page
Loading...
