Disc cannot be ejected by OPEN/CLOSE button
8.1. Forcible Disc Eject
8.1.1. When the power can be turned off.
1. Turn off the power and press [STOP] [CH UP] keys on the front
panel simultaneously for 5 seconds.
8.1.2. When the power can not be turned off.
1. Press [POWER] key on the front panel for over 10 seconds to turn
off the power forcibly, and press [STOP] [CH UP] keys on the front
panel simultaneously for 5 seconds.
8.2. When the Forcible Disc Eject can not be done.
1. Turn off the power and pull out AC cord.
2. Remove the Top Case.
3. Remove the Front Panel.
4. Remove 4 screws and Upper Base Unit from DVD-RAM Drive.
5. Take out the disc and put the Opener Roller on fully position for
direction of Arrow.
6. Put the Upper Base Unit so that the Opener Roller is inserted into
the groove.
7. Check center of Opener Roller is seen through the Opener
position Checking Hole, and tighten 4 screws.
10
To Next Page
Loading...
Need help?
General
