42
RQT7301
Reference
Error messages
On the television Page
On the unit’s display
Cannot finish recording
completely.
≥The program was copy-protected.
≥The disc may be full.
—
—
Cannot play. ≥You inserted an incompatible disc (Discs recorded in PAL video etc.). —
Cannot record on the disc. ≥The disc may be dirty or scratched. 15
Unable to format.
Please check the disc.
Cannot record. Disc is full. ≥Create space by erasing any unnecessary titles. [RAM]
≥Use a new disc. [RAM] [DVD-R]
24, 29, 33
—
Cannot record. Maximum
number of titles exceeded.
Error has occurred. Please
press ENTER.
≥Press [ENTER] to start recovery process. You cannot operate the unit while it is recovering
(“SELF CHECK” appears on the unit’s display).
—
No disc ≥The disc may be upside down. —
Please change the disc. ≥There may be a problem with the disc. Press [< OPEN/CLOSE] to remove it and check it
for scratches or dirt. (The unit turns off automatically after you open the tray.)
15
This is a non-recordable disc. ≥The unit cannot record on the disc you inserted. Insert a DVD-RAM or unfinalized DVD-R.
≥You inserted an unformatted DVD-RAM. Format the disc with this unit.
—
33
This disc is not formatted
properly.
$
≥The operation is prohibited by the unit or disc. —
CHK REMOTE
(“∑” stands for a number.)
≥The remote control and main unit are using different codes. Change the code on the
remote control.
Press and hold [ENTER] and the indicated number button at
the same time for more than 2 seconds.
14
HARD ERR ≥If there is no change after turning the unit on and off, consult the dealer where the unit was
purchased.
—
NO READ ≥The disc is dirty or badly scratched. The unit cannot record, play, or edit.
≥You have used a DVD-RAM/PD lens cleaner and it has finished. Press [< OPEN/CLOSE]
to eject the disc.
15
—
PROG FULL ≥There are already 16 timer programs. Delete unnecessary timer programs. 21
SELF CHECK ≥There was a power failure or the AC plug was disconnected while the unit was on. The unit
is carrying out its recovery process. Wait until the message disappears.
—
UNSUPPORT ≥You have inserted a disc the unit cannot play or record on. 15
U14 ≥The unit is hot.
The unit switches to standby for safety reasons. Wait for about 30 minutes until the
message disappears.
Select a position with good ventilation when installing the unit. Do not block the cooling fan
on the rear of the unit.
—
U99 ≥The unit fails to operate properly. Press [POWER Í/I] on the main unit to switch the unit to
standby. Now press [POWER Í/I] on the main unit again to turn the unit on.
—
7301en.book 42 ページ ２００４年３月１日 月曜日 午後５時３５分
To Next Page
Loading...
