21
7.1.2. (DVD) Special Modes Setting
Item FL display Key operation
Mode name Description Front Key
TEST Mode *All the main unit's parameters (include tuner)
are initialized.
Press [VHS to DVD COPYING],
[REC] and [OPEN/CLOSE] keys
simultaneously for five seconds
when power is off.
Rating password The audiovisual level setting password is ini-
tialized to “Level 8”.
Open the tray, set DRIVE SELECT
to DVD, and press [REC] and
[PLAY] simultaneously for 5 sec-
onds.
Service Mode Setting every kind of modes for servicing.
*Details are described in “7.1.3. (DVD) Ser-
vice Mode at a glance”.
When the power is off, press [VHS
to DVD COPYING], [OPEN/CLOSE]
and [STOP] keys simultaneously for
5 seconds.
Forced disc eject Removing a disc that cannot be ejected.
The tray will open and unit will shift to P-off
mode.
*When Timer REC is ON or EXT-LINK is ON,
execute " Forced disc eject " after releasing
Timer REC or EXT-LINK.
*This command is not effective during "Child
lock" is ON.
While Demonstration Lock is being set, this
Forced disc eject function is not accepted.
The display before execution
leaves.
When the power is off, press
[STOP] and [CH UP] keys simulta-
neously for 15 seconds.
Child lock/unlock Set or release “Child Lock”. Press [OK] and [RETURN] by
remote controller simultaneously
until [X-HOLD] is displayed.
NTSC/PAL system select To switch PAL/NTSC alternately. The display before execution
leaves.
While the power is on (E-E mode),
press [STOP] and [OPEN/CLOSE]
simultaneously for 5 seconds.
Forced power-off When the power button is not effective while
power is ON, turn off the power forcibly.
*When Timer REC is ON or EXT-LINK is ON,
execute “Forced Power-off” after releasing
Timer REC or EXT-LINK.
Display in P-off mode. Press [POWER] key over than 4
seconds.
Aging Perform sequence of modes as * Aging
Description shown below continually.
Display following the then mode. Set DRIVE SELECT to DVD.
When the power is ON, press [CH
DOWN], [VHS to DVD COPYING]
and [OPEN/CLOSE] simulta-
neously for over 5 seconds and less
than 10 seconds.
Note:
If the unit has hung-up because of
pressing keys for over 10 seconds,
once turn off the power, and re-exe-
cute this command.
*When releasing Aging mode, press
[POWER] key, AC-OFF.
To Next Page
Loading...
