Panasonic DP-0 Series - Connection Cable

4
Digital Pressure Sensor DP-0 SERIES
Environmentally
friendly
Connection cable *
* Options: 1 m 3.281 ft / 3 m 9.843 ft / 5 m 16.404 ft types are also available.
Three output modes
Equipped with three output modes for use in a wide range of applications
Designed for easy installation
Panel mounting bracket
H (Hysteresis)
P-1
0
ON
OFF
Comparative
output
Pressure
P-1
P-2
0
P-1
P-2
0
ON
OFF
Comparative
output
H (Hysteresis)
Pressure
H (Hysteresis)
H (Hysteresis)
Comparative
output
ON
OFF
Pressure
H (Hysteresis)
P-1
0
ON
OFF
Comparative
output
Pressure
P-1
P-2
0
P-1
P-2
0
ON
OFF
Comparative
output
H (Hysteresis)
Pressure
H (Hysteresis)
H (Hysteresis)
Comparative
output
ON
OFF
Pressure
H (Hysteresis)
P-1
0
ON
OFF
Comparative
output
Pressure
P-1
P-2
0
P-1
P-2
0
ON
OFF
Comparative
output
H (Hysteresis)
Pressure
H (Hysteresis)
H (Hysteresis)
Comparative
output
ON
OFF
Pressure
(1) EASY mode
This mode is used for comparative output ON/
OFF control.
(2) Hysteresis mode
This mode is used for setting comparative
output hysteresis to the desired level and for
carrying out ON/OFF control.
(3) Window comparator mode
This mode is used for setting comparative
output ON and OFF at pressures within the
setting range.
*H: 4 digits (xed) (10 digits or more when using psi unit) *H: 2 digits or more (5 digits or more when using psi unit) *H: 4 digits or more (10 digits or more when using psi unit)
Tight installation is possible
An exclusive mounting bracket
that is suitable for 1 to 3 mm 0.039
to 0.118 in panel thickness is
available.
Exclusive mounting bracket Connection cable
Supports tight installation
Space savings can also be
achieved even when an
L-shaped mounting
bracket is used.
Cable can be connected with one-touch
Connector attached cable (2 m 6.562 ft), as an
accessory, can be connected easily with one-touch
connection.
Types without connector attached cable are
also available
Commercially-available connectors can be used for cable
connections. Cables in required length can be used, so this
contributes to reduction in waste of unwanted cables.
Tight installation is possible
Panel mounting bracket
MS-DP1-8
Front protection cover
MS-DP1-3
Neat and
space saving
A single
mounting hole
Positioning bosses for easier
mounting bracket installation
Tight installation is possible
M3 (length 6 mm 0.236 in)
screws with washers
(Accessory for MS-DP1-1)
M3 (length 6 mm 0.236 in)
screws with washers
(Accessory for MS-DP1-5)
Ceiling mounting Floor mounting
Rear mounting
MS-DP1-5
MS-DP1-1
* Refer to p.
5 for recommended commercially-available connectors.
DP-00□-J
Commercially-available
parts can be used!