Panasonic DP-100 series - MENU SETTING MODE; Comparative output 1 mode setting; Comparative output 2 mode setting; Analog voltage output; external input

5
From RUN mode, press for 2s to select the menu setting mode.
The examples below begin with the factory default settings.
<RUN mode>
Press 2s.
<Mode setting for comparative output 1>
 Standard type
<Mode setting for comparative output 2>
1
 Multifunction type
<Analog voltage output / external input>
 Standard type
<N.O. / N.C. selection>
1, 2
 Multifunction type
<N.O. / N.C. selection>
<Response time setting>
<Display color for the main display>
<Pressure unit selection>
3, 4
<Run mode>
10 MENU SETTING MODE
Item Description
Comparative output 1
mode setting
Sets operation of comparative output 1.
Comparative output 2
mode setting
(Standard type only)
Sets operation of comparative output 2.
Analog voltage output /
external input
(Multifunction type only)
Selects analog voltage output, auto-refer-
ence input, or remote zero-adjustment
input.
N.O. / N.C. selection Selects normally open (N.O.) or normally
closed (N.C.).
Response time setting Sets response time in milliseconds (ms).
Response times available: 2.5, 5, 10, 25,
50, 100, 250, 500, 1000, 5000ms
Display color for the
main display
Selects color of main display.
Pressure unit selection Selects desired pressure unit.
1
If for the standard type DP-100 comparative output 2 is set to “OFF”, the N.O. /
N.C. selection (normally open, normally closed selection) is the same as for the
multifunction type, i.e. you will only set N.O. or N.C. for comparative output 1, not
for both comparative outputs.
2
The default setting of the high pressure type is N.O. (normally open), and that of
the low pressure type is N.C. (normally closed).
MODE
MODE
EASY mode
Hysteresis
mode
Window
comparator
mode
MODE
EASY mode
Hysteresis
mode
Window
comparator
mode
OFF mode
Auto-reference
input
Remote
zero-adjustment
input
Analog voltage
output
MODE
Output 1: N.O.
Output 2: N.O.
Output 1: N.O.
Output 2: N.C.
Output 1: N.C.
Output 2: N.O.
Output 1: N.C.
Output 2: N.C.
N.O. N.C.
MODE
3
The default setting for the low pressure type is kPA. MPA is not available.
4
For the high pressure type, “inchHg” and “mmHg” are not available.
࡮࡮࡮࡮࡮
࡮࡮࡮࡮࡮
(5000ms)(5ms)(2.5ms)
MODE
Green when ON
Red when OFF
Always redRed when ON
Green when OFF
Always green
MODE
MODE
(MPa) (kPa) (bar)
(mmHg)
(inchHg) (psi)
(kgf/cm
2
)
Rugghölzli 2
CH - 5453 Busslingen
Tel. +41 (0)56 222 38 18
Fax +41 (0)56 222 10 12
mailbox@sentronic.com
www.sentronic.com
Produkte, Support und Service
SEN
TRONIC
AG