Panasonic DP-100 series - SPECIFICATIONS

17 SPECIFICATIONS
Item
Standard type Multifunction type
Low pressure type High pressure type Low pressure type High pressure type
Pressure type Gauge pressure
Rated pressure range -100 to + 100kPa -0.1 to +1.0MPa -100 to + 100kPa -0.1 to +1.0MPa
Set pressure range -100 to + 100kPa -0.1 to +1.0MPa -100 to + 100kPa -0.1 to +1.0MPa
Pressure resistance 500kPa 1.5MPa 500kPa 1.5MPa
Applicable fluid Non-corrosive gas
Supply voltage 12 to 24V DC 10%, Ripple P-P 10% or less
Power consumption • Normal operation: 840mW or less (current consumption 35mA or less at 24V supply voltage)
• ECO mode (STD): 600mW or less (current consumption 25mA or less at 24V supply voltage)
• ECO mode (FULL): 480mW or less (current consumption 20mA or less at 24V supply voltage)
Comparative output NPN output type
• NPN open-collector transistor
• Maximum sink current: 100mA
• Applied voltage: 30V DC or less (between
comparative output and 0V)
• Residual voltage: 2V or less (at 100mA sink current)
PNP output type
• PNP open-collector transistor
• Maximum source current: 100mA
• Applied voltage: 30V DC or less (between
comparative output and +V)
• Residual voltage: 2V or less (at 100mA source
current)
Output operation Either N.O. or N.C., selectable
Hysteresis Min. 1 digit (variable). When using psi units, 2 digits.
Repeatability 0.1% F.S.
 within 2 digits
0.2% F.S.
 within 2 digits
0.1% F.S.
 within 2 digits
0.2% F.S.
 within 2 digits
Response time (ms) 2.5, 5, 10, 25, 50, 100, 250, 500, 1000, 5000ms, selectable
Analog voltage output
_
• Output voltage: 1 to 5V
• Zero point: within 3V
5% F.S.
• Span: within 4V 5% F.S.
• Linearity: within 1% F.S.
• Output impedance: approx.
1k
• Output voltage: 0.6 to 5V
• Zero point: within 1V
5% F.S.
• Span: within 4.4V 5% F.S.
• Linearity: within 1% F.S.
• Output impedance: approx.
1k
External input
_
• ON voltage: NPN type: 0.4V DC or less, PNP type: 5V to
+V DC
• OFF voltage:
NPN type: 5 to 30V DC or open, PNP type:
0.6V DC or less or open
• Input impedance: approx. 10k
• Input time: 1ms or more
Ambient temperature -10 to +50°C (No dew condensation or ice formation allowed). Storage: -10 to +60°C.
Ambient humidity 35 to 85% RH. Storage: 35 to 85% RH.
Temperature characteristics 0.5% F.S.
(20°C reference)
1% F.S.
(20°C reference)
0.5% F.S.
(20°C reference)
1% F.S.
(20°C reference)
Material Enclosure: PBT (with glass fiber); LCD display: acrylic; Pressure port: stainless steel (SUS 303); Mounting screws:
brass (nickel-plated); O-ring: H-NBR; Switch: silicon rubber
Weight 40g approx. (DP-100-E type: 45g approx., DP-100-M type: 30g approx.) (Main body only)
Accessories CN-14A-C2 (Cable with a connector, 2m long; optional for J type). Unit switching label: 1 pc.
Rugghölzli 2
CH - 5453 Busslingen
Tel. +41 (0)56 222 38 18
Fax +41 (0)56 222 10 12
mailbox@sentronic.com
www.sentronic.com
Produkte, Support und Service
SEN
TRONIC
AG