Panasonic DP-190 - Page 68

68
UF-9000
JUN 2004
Ver. 2.0
DP-180/190
4.1.5. F6 Mode: Adjust Parameters (For Copier)
Set the machine to Service Mode and press "6" key on the Keypad.
↓
Press the "START" key.
↓
Enter the desired code number or press “V”, ”/\” arrow keys.
↓
Press the "SET" key.
↓
Enter the desired function code number and press “SET” key.
↓
When the “CLEAR” key is pressed, the selected code input will not be accepted.
↓
Press “STOP” key, then press “FUNCTION” and “CLEAR” keys simultaneously to exit the service mode.
↓
Reboot the machine after setting the parameter(s) to activate the setting(s).
Note:
1. The Factory Setting is different in each model.
2. The machine may accept a (+/-) input value that exceeds the specified Setting Range for the
parameters in the table; however, the actual registered value will not exceed the Upper/Lower
Limitation value.
F6 Mode
No. Item Remarks
Setting
Range
00-02 Not Used
03 Original Registration Adjustment of platen original registration
detection timing.
-30 - +30
0.2mm
04 Printer Registration Delay time is adjusted from registration roller
clutch ON.
-50 - +16
0.5mm
05-06 Not Used
07 Registration Void Registration void should be adjusted. 0 - +99
0.5mm
08 Trail Edge Read Timing Adjustment of trail edge void. -9 - 0
0.5mm
09 Trail Edge Print Timing Adjustment of trail edge void. -9 - +15
0.5mm
10 Side Adjust (Bypass) Adjustment of LSU side-side (Sheet Bypass). -8 - +7
0.5mm
11 Side Adjust (Tray 1) Adjustment of LSU side-side (1st Tray). -8 - +7
0.5mm
12 Side Adjust (Tray 2) Adjustment of LSU side-side (2nd Tray). -8 - +7
0.5mm
13-15 Not Used
16 Side Adjust (ADU) Adjustment of LSU side-side (ADU). -8 - +7
0.5mm
17-32 Not Used
33 TDC Max. Read Only Set by Digital QUANTUM (QUARC) control -99 - +99
(Read only)
34 TDC Min. Read Only Set by Digital QUANTUM (QUARC) control -99 - +99
(Read only)