EasyManua.ls Logo

Panasonic DP-190 - Page 86

Panasonic DP-190
188 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
86
UF-9000
JUN 2004
Ver. 2.0
DP-180/190
Note:
1. The contents of the Function Parameter List may vary depending on the country’s regulations.
2. “ * ” mark will be shown on the left side of number when setting was changed from default.
Function Parameter List (Sample)
************* -FUNCTION PARAMETER- ************* DATE MMM-dd-yyyy ***** TIME 12:07 ***P.01
-PANASONIC -
Note: The power must be reset for the new parameter settings to take effect.
***** ******************* -PANASONIC - ****** -12345678901234567890- *********
000 Mon/Tel Dial:[Monitor] Monitor 050 Ring Det Mode:[Normal] Normal
001 Alarm Status:[Timer] Timer 051 ----------
002 Stop Comm. JRNL:[On] On 052 Pulse Rate:[10pps] 10pps
003 Continuous Polling:[Off] Off 053 ----------
004 Numeric ID Set:[On] On 054 ----------
005 Destination Code:[999] 999 055 Busy Tone Check:[On] On
006 ID Display:[Chara] Chara 056 ----------
007 JRNL Column:[Station] Station 057 ----------
008 Monitor:[Off] Off 058 Comm.JRNL +Image:[On] On
009 DC Loop:[Off] Off 059 Conf.RCV Report:[On] On
010 TX Level:[-11dBm] -11dBm 060 Version: UF-9000 AAV......
011 RX Level:[-43dBm] -43dBm 061 TX/RX/PRT/CPY: 000080/000168/000003/000000
012 DTMF Level:[-5dBm] -5dBm 062 Print Counter:[Off] Off
013 G3 RX EQL:[0dB] 0dB 063 ----------
014 G3 TX EQL:[0dB] 0dB 064 ----------
015 --------- 065 ----------
016 --------- 066 ----------
017 TX Start:[14400bps] 14400bps 067 ----------
018 RX Start:[14400bps] 14400bps 068 NYSE Fax Forward:[Off] Off
019 ITU-T V.34:[On] On 069 NYSE Local Print:[inc] inc
020 ITU-T ECM:[On] On 070 Line Error:[128] 128
021 EP Tone:[Off] Off 071 Total Error:[10] 10
022 Sig. Interval:[500ms] 500ms 072 Conti. Error:[Off] Off
023 TCF Check:[Normal] Normal 073 Error Detect:[Rate] Rate
024 CED Freq.:[2100Hz] 2100Hz 074 RTN Receive:[Discon] Discon
025 Comm. Start-Up:[1'st] 1'st 075 Coding:[JBIG] JBIG
026 Non-Standard:[On] On 076 Batch TX:[On] On
027 Short Protocol B:[On] On 077 RX JAM Length:[2 m] 2 m
028 Short Protocol D:[On] On 078 ----------
029 Remote Diag.:[On] On 079 ----------
030 CED & 300bps:[75ms] 75ms 080 Doc Top Feed:[0] 0
031 RTC=EQL x 12:[Off] Off 081 Doc End Feed:[0] 0
032 V34TX Start:[33600bps] 33600bps 082 JAM Length:[2 m] 2 m
033 V34RX Start:[33600bps] 33600bps 083 ----------
034 V34 TX SR:[3429sr] 3429sr 084 Line As Nopaper:[Ring] Ring
035 V34 RX SR:[3429sr] 3429sr 085 ----------
036 --------- 086 ----------
037 Protocol Display:[Off] Off 087 Darker Level:[2] 2
038 --------- 088 Normal Level:[8] 8
039 Flash Time:[500ms] 500ms 089 Lighter Level:[14] 14
040 --------- 090 ----------
041 Pause Time:[3sec] 3sec 091 ----------
042 --------- 092 Smoothing:[On] On
043 Redial Interval:[3min] 3min 093 ----------
044 Redial Count:[5] 5 094 ----------
045 Ring Det. Count:[2] 2 095 Reduction Ratio:[100%] 100%
046 On-Hook Time:[5sec] 5sec 096 ----------
047 Response Wait:[5sec] 55sec 097 ----------
048 --------- 098 ----------
049 --------- 099 ----------

Other manuals for Panasonic DP-190

Related product manuals