60
UF-9000
APR 2006
Ver. 3.0
DP-180/190
2.2.8. Fuser Unit
CAUTION:
To prevent from getting burned, do not install, remove, clean or make adjustments when the Fuser Unit is
hot.
(1) Remove the Rear Door. (Refer to 2.2.4.1.)
(2) Remove the Scanner Unit and Upper Cover.
(Refer to 2.2.7.)
(3) Disconnect 2 Harnesses by pressing down on
the connector latches with a small screw driver.
(4) Remove 4 Screws (T9).
(5) Remove the Upper Exit Roller Holder (1101).
(6) Disconnect the Harness (1219) on the LVPS
Unit.
(7) Remove the Ferrite Core (1115).
(8) Remove 4 Screws (U4) and 1 Screw (U1).
(9) Remove the Fuser Unit.
To Next Page
Loading...
