776
JAN 2006
Ver. 5.2
DP-3510/3520/3530/4510/4520/4530/6010/6020/6030
Fig. 3-022
(7) Turn the Gear [16] to align the round hole in the
Staple Driver Gear with the Round Hole [17] at
the back.
Fig. 3-023
(8) Insert a Pin [18] with a diameter of approximately
2 mm (use of a 2 mm Allen wrench is
recommended) in the Round Hole to secure the
Gear.
Fig. 3-024
(9) Turn the Gear [19] to align the Round Hole in the
Staple Clincher Cam with the Round Hole [20] at
the back.
[16]
[17]
[18]
[19]
[20]
To Next Page
Loading...
