STEP 1 Connection to a television
Do not connect through the video cassette recorder. Due to copy guard protection, the picture may not display properly.
Turn off all equipment before connection and read the appropriate operating instructions.
Connect the terminals of the same colour.
Unless otherwise indicated, illustrations are of areas except Continental Europe.
(
Continental Europe
:There is no S VIDEO OUT terminal on the unit.)
•
•
•
•
•
Television
You can connect the audio cable to the 2-channel
audio input terminals of an analog amplier or
system component to enjoy stereo sound.
To enjoy progressive video
Connect to a progressive output compatible television.
1.
Continental Europe
Set “VIDEO OUT-SCART” to “VIDEO/YPbPr” for component terminals
(
è page 16, “VIDEO” tab).
2. Set “VIDEO OUT (I/P)” to “PROGRESSIVE”, then follow the instructions
on the menu screen (è page 16, “VIDEO” tab).
Continental Europe
Panasonic televisions with 625 (576)/50i · 50p, 525 (480)/60i · 60p input
terminals are progressive compatible.
]1
When using this connection, the audio cable
(red and white plugs) should also be connected.
With COMPONENT VIDEO IN
With VIDEO IN or S VIDEO IN
S video cable
]1
Audio/video cable
]2
Not used
Video cable
Back of the unit
Continental Europe
With SCART (AV) IN
21-pin SCART
cable
If the television is compatible
with S-video, set “VIDEO
OUT-SCART” to “S-VIDEO/
YPbPr”, or compatible
with RGB, set “VIDEO
OUT-SCART” to “RGB/NO
OUTPUT” (è page 16,
“VIDEO” tab).
•
Audio/video
cable
]2
]2
(
Except Continental Europe
included)