8
RQT8112
Basic play
Standby/on switch (Í/I)
Press to switch the unit from on to standby mode or vice versa. In standby mode, the
unit is still consuming a small amount of power.
≥ To play JPEG, MPEG4 or DivX video contents on DVD-RAM that contain both [RAM]
and another format (e.g. [JPEG]), select “Play as Data Disc” (➜ page 15, Other Menu).
≥ “D.MIX” on the display indicates that a soundtrack with three or more channels can be
down-mixed to two channels (➜ page 23, Glossary).
≥ Discs continue to rotate while menus are displayed. Press [∫] when you finish to
preserve the unit’s motor and your television screen.
≥ Total title number may not be displayed properly on iR/iRW.
AV
ENHANCER
ADVANCED
DISC REVIEW
CM SKIP
QUICK REPLAY
CANCEL
SKIP
DIRECT NAVIGATOR
PLAY LIST
MENU
TOP MENU
STOP PAUSE PLAY
SLOW/SEARCH
QUICK OSD
FL SELECT
OPEN/CLOSE
123
45
789
0
10
6
RE-MASTER
MULTI
REPEAT
DEPTH ENHANCER
2
4
1
POWER
PauseStop
1Power ON.
2Open the disc tray.
3Load the disc.
4Start play.
Remote control sensor
≥
Load double-sided discs so the label for the side you want to play is facing up.
≥[RAM]
Remove discs from their cartridges before use.
Skip
≥ [RAM] [DVD-RW[‹VR›]
Can also skip to the markers.
Stop
The position is memorized when “!” flashes on the display.
≥ Press [1] (PLAY) to resume.
≥ Press [∫] to clear the position.
≥ Even after the unit is turned off, the position is memorized
(Normal playback only).
Search (during play)
Slow-motion (during pause)
≥ Up to 5 steps
≥ Press [1] (PLAY) to restart play.
≥ [VCD] Slow-motion: forward direction only
≥ [MPEG4] [DivX] Slow-motion: Does not work.
Pause
≥ Press [1] (PLAY) to restart play.
Displaying current playback
condition ➜ page 9
If you are experiencing problems, refer to troubleshooting guide (➜ page 21
–
22).
Basic play
8
RQT8112‑En.fmPage8Tuesday,July19,200510:53AM
To Next Page
Loading...
