Panasonic EP-MA70 - Tips of Disassembly and Assembly of the Massage Mechanism Block; Removing the Up;Down Sensor; Caution in Installing

EP-MA70
ORDER NO. HPD1102U24CE
- 32 -
6.14. Tips of disassembly and assembly of the Massage mechanism block
6.14.1. Removing the Up/down sensor
1. Disconnect the connector (CN106) on the Main PCB.
2. Cut the Cable tie T30R x 2, T18S x 1, which bind the Lead wires.
3. Remove two screws on the Up/down gear box B and the Up/down sensor install stand, and remove
the Up/down sensor.
Caution in installing
When installing the Up/down sensor, make the leg of the Sensor install stand fit into the groove of the
Up/down gear box B.