Panasonic EP-MA70

EP-MA70
ORDER NO. HPD1102U24CE
- 66 -
9.9. Checking after assembly [CA]
Check if the Massage mechanism block is properly assembled or there is nothing wrong with the Sensors
or Motors. ＊Detect failures in Sensors or Motors.
1. Proceed the procedures of 9.1. Preparation of Secret Mode.
2. Push the button of BACK INTENSITY till CA appears, and push the OK button.
3. Massage mechanism block starts operating. If there is nothing wrong, it stops normally.
4. If the operation stops halfway, push the buttons of Off/On or Stop on the Controller.
9.10 Adjustment of Body pressure sensor [CC].
1. Proceed the procedures of 9.1. Preparation of Secret Mode
2. Push the button of BACK INTENSITY till CC appears, and push the OK button. Any of the following is
shown.
3. Push the OK button again.
4. Push the Off/On button on the Controller. The adjustment is done.