Panasonic EP-MAN1 - Cushion and Controller Holder Assembly; Controller Holder Installation; Pillow and Comfort Cushion Attachment

6
Attach the left hand side in the
same way
7
Attach the controller to the controller holder
9
Attaching the comfort cushion
8
Attaching the pillow
■
How to tighten
the screws
●
Screw may be damaged
if you tighten the screw
inserted into the hole
crookedly using an allen key.
①
Place the screw on the tip of
a allen key.
②
Tighten the screw while
ensuring that the screw hole
and the screw head become
flat.
Allen key
Screw holes
Attachment
screws
Recommended position of the pillow when using the massage lounger. (EN16)
The controller stand and controller holder cannot be replaced with the left armrest.
Pillow
Velcro fastener Velcro fastener
The one with
the tag is
higher
5
Check for misaligned screw holes
and secure with mounting screws
◦
To remove the controller, lift it up.
①
Insert the controller cord
into the recess of the
controller holder
③
Push it in until it clicks
into place
②
Align the groove on
the back of the
controller horizontally
with the convex part
of the controller holder
and slide it into place
Concave part
Controller cord
Groove
Convex part
Back side of
controller
Fastener Comfort cushion
Attach the cushion using the fastener.
●
When the Comfort cushion is attached, the chair can be used as a chair.
Attach the pillow using the velcro fastener.
Down
Up
Assembly
EN13