Always carry
the lounge with at
least two people!
Setting up the massage lounger
Lay out a mat, etc.
Since the unit may damage the flooring, it is
recommended to place the unit on a mat.
When placing a mat under the unit, the
size of the mat should be sufficient (at
least 130 cm × 70 cm) to cover the areas
where the unit touches and where the
legrest could touch the floor.
Do not hold by the foot
part.
The sole massage section
might slide, and injuries
may occur.
①
The unit must be carried by two or
more persons.
●
Since the unit is heavy, be careful to
avoid back injuries.
Unit weight
Approx. 91 k
g
②
Watch your step carefully and put
down the unit slowly.
Place your fingers
in the groove
■
Hold the sides of the legrest.
■
Hold the legrest with your
hands until it has been set
on the floor completely.
●
If you release the legrest too
soon, it will spring back to the
initial position.
Attached to the
main unit at
purchase.
Sole cover
4 mm
(Cross section)
Allen key (1 pc.) Attachment
screws
(M6×13)
Black
(2 pcs)
Ensure there is adequate space to recline.
Unit body dimensions
Height approx. 122 cm × Width* approx. 85 cm × Depth* approx. 200 cm
(See EN53 for detailed unit dimensions.)
* When installing near a wall, etc.
In the reclining state, make sure that the backrest and the legrest are separated from walls, etc., by 10 cm or more,
and the armrest is separated from walls, etc., by 5 cm or more.
●
Do not expose the massage lounger to direct sunlight or high temperatures, such as in front of heating sources.
This can cause discoloration or hardening of the synthetic leather.
Armrests (Left/Right)
Pillow
Comfort
cushion
Power cord
Left/Right indication (armrest back)
Controller stand
and controller
holder are located
on the right
armrest.
1
Checking the accessories
2
Where to use the unit
3
Installing
EN10
To Next Page
Loading...
