Controller
Screen displays during massaging operations
Press
●
When the button is pressed, a "Beep"
confirmation sound is heard and the unit
moves one step at a time.
●
Press and hold to keep it moving until you
hear a "Beep-beep-beep" sound.
Setting and canceling the child lock
If this setting is made, the operations are no longer accepted.
■
How to set
Long press for about 5 seconds when the power supply of the controller is turned OFF or when the user
selection / registration screen is being displayed.
■
How to cancel
After the child lock is set, press and hold for about 5 seconds when the screen display described above
is shown or when the power of the controller is turned OFF.
●
When is pressed after the setting is made, about 10 seconds
later the supply to the controller is switched OFF automatically.
Toggle part display
The display of part can be toggled between upper body and
whole body.
●
During program editing, part display cannot be toggled.
(EN27)
Display reclining angle adjustment screen
The angle of the backrest and legrest can be
adjusted at any time by pressing .
●
If you select only those areas where only air
operates, the screen below will be displayed.
(See EN30 for air massage operations.)
Display of the operation, position, and pressure
The statuses of massage rollers in operation, as well as sole
and air are displayed.
(The actions shown represent rough movements. Actual
movements or sensations may vary.)
Sole
ㅡ
rotates during
operation.
Air (Example: In case of air arm course)
Arm/Leg/Sole
actions
Operation Off/On,
hard/gentle display
(EN34 to EN35)
Setting of air: Off
Setting of air: On
Air operating
The color of the
body part changes
continuously.
Massage rollers
●
The color becomes darker as
the pressure on the massage
rollers becomes higher.
●
The following screen is displayed,
and about 10 seconds later the power
is switched OFF automatically.
Press
Press
Part names and functions of the controller
EN19
To Next Page
Loading...
