Panasonic EP-MAN1 - Page 23

Perform tapping action to easily confirm
that the massage roller is in the correct
position.
●
If the shoulder position is not correct, use
"▲"and"▼"tomakefineadjustments
then press "OK".
(Check below for details)
●
If the shoulder position is correct, press
"OK" to confirm.
( If "OK" is not pressed, it will be
automatically OK after about 12
seconds.)
After the shoulder position is OK, the display
switches to the massage screen and massage
begins.
●
The approximate height is estimated
based on the shoulder position,
and the angle of the legrest may be
automatically adjusted so that the soles
of the feet are flat.
Complete
Fine-tune the shoulder
position during the
tapping action
Too high
Correct position of the
massage roller
(The point where the tapping
action should be felt.)
Too low
●
If the shoulder position shifts significantly,
stop the operation by pressing once, sit
back so that your hips touch the backrest, and
operate again.
■
Shoulder tapping position is not aligned
①
Press"▲"or"▼"duringthetappingaction(about
12 seconds) to adjust the shoulder height position.
②
Press "OK".
Moves approx. 1.2 cm up or down for each press.
When "OK" is pressed, the scanning of shoulder
roller position is completed.
Scanning of shoulder roller position
EN23