Continued on the next page
Question Answer
During operation
(continued)
Reclining
The angle of the backrest, legrest
or armrest automatically changes
at times.
The angle automatically changes in the following cases.
ㅡ
While scanning the shoulder roller position
The unit body moves automatically, and gets inclined to the angle
that makes scanning easy.
●
If you have adjusted the reclining before use, the angle will not change.
Reclines around 25°
Raises
around 60°
ㅡ
When is pressed to end the massage.
ㅡ
When finished by timer
Backrest and legrest will return automatically.
●
If the backrest and legrest angle is set to "Leave in place" in the
settings, it will not return automatically. (EN37)
●
If you exit with , the angle does not change automatically and
all operations stop on the spot.
●
It may change automatically when performing stretching movements.
You do not want to return
backrest / legrest after timer
expires
If the backrest and legrest angle is set to "Leave in place", the
backrest / legrest will not return automatically after the timer
expires. (EN37)
Backrest / legrest does not return
after the timer ends
●
After the timer ends, press the
Return the backrest and legrest
displayed on the control panel.
●
If the controller is turned off, press twice.
It displayed as not being able to
finish correctly last time...
It is displayed in the following cases
ㅡ
Previously shut down due to power outage
ㅡ
Stopped by turning the power switch on the back of the main unit
to (
○
) "OFF" or unplugging the power plug from the outlet before
normal termination operation
Press "OK"
After stowing the backrest or legrest in its original position, resume the
operation.
After use
Hand & arm
Red marks are left on the under
side of my hands / arms after a
hand & arm massage.
Marks may remain on the hands and arms after use. These
eventually fade and are not a problem.
Q&A
EN45
To Next Page
Loading...
