Panasonic FP2

SpecificationsFP2−CCU
6 − 3
6.1 Specifications
6.1 Specifications
General Specifications
Item Specifications
Ambient temperature
0to55°C/32 to 131 °F
Storage temperature
–20 to +70 °C/– 4 to + 158 °F
Ambient humidity
30 to 85 % RH (at 25°C non−condensing)
Storage humidity
30 to 85 % RH (at 25°C non−condensing)
Vibration resistance 10 to 55 Hz, 1 cycle/min.: double amplitude 0.75 mm (0.03 in.),
10 min. on 3 axes
Shock resistance Min. 98 m/s
2
, 4 times on 3 axes
Noise resistance
1000 V
p−p
, 50 ns, 1 μs pulse widths (based on in−house measurements)
Operating condition Free of corrosive gases and excessive dust
Computer Communication Unit Performance Specifications
Item Specifications
Interface Two RS232C ports
Transmission distance Max. 15 m/49.212 ft
*
1
Transmission speed (Baud rate) 19,200/9,600/4,800 bits/s, selectable using DIP switch
Communication method Half duplex
Synchronous method Start−stop synchronous method
Transmission code ASCII
Transmission data format Stop bit: 1−bit
Parity: Valid (odd)
Character bits: 7−bit/8−bit, selectable using DIP switch
Data transmission order 0 bit first in units of characters
End terminal code CR (0DH)
Computer linking Message Header (%) to terminator (CR) Once transmission rights from the
host computer are received, com-
Maximum message length Max. 118 characters/frame
(including “%” and “CR”)
host
computer
are
received
,
com
munication is started. The commu-
nication protocol is MEWTOCOL−
COM.
Current consumption 60 mA or less (at 5 V DC)
Weight Approx. 120 g/4.233 oz
*1: The value is given as 15 m/49.212 ft. in the specifications, but if used in an environment with a high noise level,
communication may be unstable. Check the conditions using the actual device.
Note
This unit does not support extension header (<). Use the Multi
Communication Unit.